It is not uncommon to experience total brake failure after a long, hard period of braking – just when you want full brake power. By far the most likely cause is that the high heat generated in the brake callipers has raised the brake fluid above the boiling point of water, i.e.
Once the fluid has cooled to below 100°C, the water vapour condenses back into water. Water is not compressible, so the brakes feel normal again. Normal brake fluid (not Silicone types/DOT5) absorbs water relatively quickly, and can easily get to 3% after a few years.
High water content in the brake fluid also encourages rusting at the calliper pistons. This rusting can, and does, cause seizure of some or all of the pistons. This in turn causes wild brake pulling to left or right, and overheating of one or more brake discs. This leads to overheating of the brake fluid, resulting in the problem outlined above.
While changing the brake fluid should be a routine maintenance or service action, it is seldom carried out – especially with classic cars which may not be used for years at a time. Changing the brake fluid regularly, however, has the benefit of keeping the water content low enough to avoid brake failure and rusting. So be warned – change the fluid every 2 years to avoid potentially lethal brake failure.
Avoid a nasty surprise by keeping on top of your classic car’s maintenance. Contact KWE to schedule your next service appointment.